WF-701REC Pulse payment device to PC

Pulse type Coin acceptor to PC interface WF-701REC

Order multiple products in one order package,that  may save shipping costs

The WF-701REC is the slave device that responds only to the polls (or requests) from the Master.In this polled system, the Master requests information from the WF-701REC at a periodic rate. This rate can be as fast as every 300 milliseconds.

WF-701REC has the “Lockout” Timer feature that it will disable the acceptor if the specified poll rate is not met. In another words, if the host system is too busy to keep up with the desired minimum poll rate, WF-701REC will put the acceptor into the disabled mode and actively stop collecting money . The acceptor will be enabled again once the communication resumes.

Specification

Power input: DC12V or DC24V (Select the right power voltage according to the motor voltage)

Motor:DC12V or DC24V motor

SIN(Sensor): NO type input

Baud Rate: 9600

Duplex:  Half Duplex

Character Format: 1 start and 1 stop bit,,8 data bits (Bits 0 = sent first (LSB)

(To coin acceptor)

The coin acceptor that can be used needs to be a single pulse type. That is, every time a coin is received, then a pulse is output. WF-701REC can inhibit the coin acceptor by powering down the coin acceptor. Coin acceptor should use the NO output type.

(To infrared sensor)

The infrared sensor is used to detect the number of coins output, that is, every time a coin is output, the infrared sensor will output a pulse to the WF-701REC. After receiving the specified number of pulses, WF-701REC will immediately stop the voltage output for the coin hopper.

 (To motor)

By supplying power to the motor in the HOPPER, the motor continuously outputs coins after the motor rotates. By turning off the power of the HOPPER, the output can be stopped